Radial Head Adjustment

Orienting the Angle Head for Single Position Machining

Initial Orientation: Because the tool changer typically loads the tool against the same side of the keyway each cycle, it is important that the tool is loaded into the machine spindle by the tool changer not by hand, prior to final adjustment.

Final Adjustment: The head (E) is attached to the shank (F) by means of a clamp collar(G). By loosening the four clamp collar screws (H) the head can be rotated 360 degrees to the desired orientation. See Figure.

Coolant Driven Angle Head Drawing

Typically a dowel or gage pin is chucked in the collet and swept with an indicator for precise positioning. The flat around the spindle is also very square to the centerline of the tool and often can be used to indicate.

Next Subject: How Do I Orient the Angle Head?

For tech help or ordering assistance, call us toll free at 1-877-435-8665 (USA).